Table of Contents
Advertisement
N6210.book Page 105 Wednesday, May 18, 2005 10:24 AM
S-Video Cable Connection
Figure B-11. S-Video Cable
To connect an S-Video cable:
The S-Video connector is keyed so that it
can only be inserted when aligned properly
with the port. Examine the orientation of
the connector with the port before inserting
it. Forcible insertion may damage the
connector and/or port.
1.
Connect the cable to the video output jack on the
external device.
2.
Connect the cable to the video input jack on the
notebook (See Figure B-12).
3.
Connect the audio cable between the external
device and the notebook, as described in "Connect-
ing an External Audio Device" on page 104.
S-Video Cable
Figure B-12. S-Video Cable Connection
GETTING STARTED
When using Instant MyMedia for the first time, setup
will begin automatically after Instant MyMedia is acti-
vated.
When performing the installation, do not
wear headphones initially; the volume may
be greater than expected.
Note that Instant MyMedia will cause the
system to reboot twice during this
installation procedure. If Instant MyMedia
fails to start after following these steps,
refer to the Troubleshooting section of this
manual.
T V T u n e r U s e r ' s G u i d e
Note that rebooting after installation of
each application is not necessary, despite
what on-screen prompts may state.
1.
Verify that the system is not powered on, then press
the MyMedia button on the remote control. During
the first portion of the installation, the notebook
will cycle through several screens as different por-
tions of the installation take place. At the end of
this portion, the notebook will turn off.
2.
Verify that the power indicator is not lit.
3.
Press the MyMedia button on the remote control
again. The last portion of the installation will begin.
At the completion of installation, the notebook will
turn off.
4.
Press the MyMedia button on the remote control
again. The Instant MyMedia main menu will
appear. Instant MyMedia is now ready to use.
SETTING UP/SKIPPING CHANNELS
Setting Up Channels
1.
Press the MyMedia button on the remote control to
display the main menu.
2.
If it's not already selected, select TV with the cursor
S-Video Port
buttons, then press the [Enter] button on the
remote control. Instant MyMedia enters TV mode.
3.
Press the [Menu] button to display the menu.
4.
Select Antenna or Cable, depending upon how your
tuner is connected. Press [Enter].
5.
In the left hand panel, select Favorite Channel List.
To automatically assign a broadcast station to unas-
signed channels, set the selection to On.
6.
Select Auto Scan with the cursor buttons, select
Run, then press [Enter].
7.
A channel search will begin. During the channel
search, channels are switched one after another;
this could take some time. Each time a channel
search is performed, different channels may be
detected due to changing reception conditions.
Skipping Channels
You can determine which detected channels are
displayed and which are skipped using the remote
control or the channel button on the notebook.
1.
Press [Menu] button to display the menu. Select TV
Channel using Cursor Move buttons.
2.
Press the right-cursor move button to enter the list
of channels. Select a channel and press the [Enter]
button. Channels with a circle to the left are the
channels that are set; they will not be skipped.
105
Advertisement
Table of Contents
Troubleshooting
