Table of Contents
Advertisement
20
EN
Instant ReView
Simply by pressing a single button, the unit power comes on,
rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the unit is off and that the Timer
mode is disengaged.
Activate Instant ReView.
Press
. The unit power comes on and the unit
searches for the index code indicating the start of the last
timer-recorded programme. Once it's found, playback
begins automatically.
● To watch the first of the 3 programmes, press
times. The unit searches and begins playback automatically.
You can access a programme as far as 9 index codes away
from the current tape position.
Repeat Playback
Your unit can automatically play back the whole tape 100 times
repeatedly.
1
Start playback.
Press 4.
2
Activate Repeat Playback.
Press 4 and hold for over 5 seconds, then release.
● The Play indicator ($) on the front display panel blinks slowly.
● After playing back a tape 100 times, the unit stops
automatically.
3
Stop Repeat Playback.
Press 8 at any time.
● Pressing 4, 3, 5 or 9 also stops Repeat Playback.
NOTE:
Repeat playback is not possible with a cassette recorded in EP
mode.
OPERATIONS ON S-VHS DECK (cont.)
Manual Tracking
Your unit is equipped with automatic tracking
control. During playback, you can override this
and adjust the tracking manually by pressing the
PR buttons.
1
Override automatic tracking.
During playback, press p on the remote
control.
2
Adjust the tracking manually.
Press PR + or – on the remote control.
● Press p again to return to automatic tracking.
NOTE:
When a new tape is inserted, the unit enters the automatic
tracking mode automatically.
Soundtrack Selection
Your unit is capable of recording three soundtracks (HI-FI L,
HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing A.MONITOR changes the soundtrack as follows:
TRACK
On-Screen Display
HI FI
L j h R
HI FI
L j
HI FI
h R
NORM
HI FI
three
NORM
NOTES:
● "HIFI L j h R" should normally be selected. In this mode,
Hi-Fi stereo tapes are played back in stereo, and the normal
audio track is played back automatically for tapes with only
normal audio.
● For instructions on recording stereo and bilingual
programmes, refer to page 23.
● "O.S.D." must be set to "ON" or the on-screen displays will
not appear. (
USE
For Hi-Fi stereo tapes
For main audio of Bilingual tapes
For sub audio of Bilingual tapes
For audio-dubbed tapes
For audio-dubbed tapes
pg. 65)
Advertisement
Table of Contents
