Table of Contents
Advertisement
RUGGEDCOM WIN7225
Installation Guide
Figure 5: Base Station and Mounting Bracket Assembly
1. Base Station 2. Mounting Bracket 3. Flat Washer 4. Screw
4.
Torque all screws to 8.9 N·m (6.6 lbf-ft).
Section 2.6
Installing Antennas
The base station is equipped with an internal omni-directional GPS antenna. It also supports an external Radio
Frequency (RF) antennas and omni-directional or directional Global Positioning System (GPS) antennas.
When selecting the ideal location for an antenna, consider the following recommendations:
• Mount the antenna at the highest possible point to improve reception.
• Select an area where there are few obstacles between the antenna and the planned coverage area or zone. A
minimum of 55% of the sky must be visible to the antenna.
• Make sure the antenna is installed at a distance from other antennas or devices that may cause interference.
• Make sure the antenna is accessible for maintenance.
CONTENTS
•
Section 2.6.1, "Installing an RF Antenna"
•
Section 2.6.2, "Installing an External GPS Antenna"
Section 2.6.1
Installing an RF Antenna
The RUGGEDCOM WIN7225 base station supports two (primary and secondary) external omni-directional or
directional Radio Frequency (RF) antennas.
Installing Antennas
Chapter 2
Installing the Base Station
1
2
3
13
Advertisement
Table of Contents
