32 Chapter 2 Cabling and LEDS
Serial interface cable
Nortel Networks ships a serial cable with the Contivity to enable configuration of
the Management IP address, subnet mask, default gateway address, and other
configurable parameters. Nortel Networks recommends that you use the IP
Address Configuration Utility diskette for easy initial IP address configuration.
Later, you can use the serial interface configuration menu to perform management
functions.
The serial cable provided with the Contivity is a DB9/DB25-to-DB9/DB25. This
provides a crossover (transmit-to-receive and receive-to-transmit). The DB9
connector goes into the Contivity and the other DB9 or DB25 connector goes into
your workstation.
cable pinouts.
Table 5 Multiple DB9 and DB25 connector pinouts
Serial Port DB9 Connector
Pinout
Signal
2
RXD
3
TXD
4
DTR
5
Ground
6
DSR
7
RTS
8
CTS
311862-A Rev 00
Note: For information on serial interface connection, refer to Managing
the Contivity Extranet Switch, Chapter 2, "Getting Started."
Table 5
shows the multiple cable DB9/DB25
Serial Port DB25 Connector
Pinout
Signal
3
TXD
2
RXD
20
DSR
7
Ground
6
DTR
4
RTS
5
CTS
Serial Port DB25 Connector
Pinout
Signal
>
2
RXD
>
3
TXD
>
6
DTR
>
7
Ground
>
20
DSR
>
5
CTS
>
4
RTS
serial interface
Serial Port DB9
Connector
Pinout
Signal
3
TXD
2
RXD
6
DSR
5
Ground
4
DTR
8
CTS
7
RTS