The External Monitor Is Blank Or The Image Is Unstable; Characters Or Digits Do Not Appear On The Screen On Entering; The Workstation Does Not Start After Switch On - Fujitsu CELSIUS Mobile H Operating Manual

Troubleshooting and tips
Ê
When using an analogue monitor check, if the monitor adapter supplied with your workstation is
connected correctly.
Ê
Switch on the external monitor and the workstation.

The external monitor is blank or the image is unstable

Two causes are possible: An incorrect type has been selected for the external monitor or the wrong
screen resolution has been set for the application programme.
Ê
Terminate the application programme with [Alt]
If the fault continues to occur after ending the programme, switch over to the workstation's internal
LCD screen with [Fn] [Fn] + [F10] [F10]. Change the following setting:
[Fn] [Fn] [F10] [F10]
Ê
Select Start - Settings- Control Panel - Display - Settings and then the screen resolution you
require in the Resolution field.
or
Ê
Select the correct monitor under Start - Settings- Control Panel - Display - Settings - Advanced
Properties - Monitor - Modify.

Characters or digits do not appear on the screen on entering

The entry speed is higher than the transfer speed of the radio keyboard.
Ê
Connect the radio keyboard to the workstation with the PS/2 cable supplied with your
workstation.

The workstation does not start after switch on

If the workstation does not start after switch on, this may be due to one of the following:
The battery is not installed correctly.
Ê
Switch off the workstation.
Ê
Check whether the battery is installed correctly in its compartment.
Ê
Switch the workstation on.
The battery is dead
Ê
Charge the battery by connecting the power adapter to the workstation.
Ê
If the battery doesn't charge, replace the battery.
Or
Ê
Install a charged battery.
The power adapter is not connected correctly.
Ê
Switch off the workstation.
Ê
Check whether the power adapter is connected correctly to the workstation.
Ê
Check whether the power cable is plugged properly into the power adapter and into the mains
outlet. The indicator on the power adapter should illuminate.
Ê
Switch the workstation on.
76
[Alt] + [F4] [Alt] [Alt] [F4]. [F4] [F4]
A26391-K124-Z100-1-7619