Fujitsu 420D User Manual page 76

S e c t i o n T h r e e
P O I N T
Power Savings parameters can also be set
without entering the Setup Utility,
through the Power Center Software.
The Power Savings Menu fields are:
SUS/RES Switch:
Smart Power Savings:
Power Savings:
Hard Disk Time-out:
Video Time-out:
Standby Time-out:
Auto Suspend Time-out:
Suspend Mode:
Resume on Modem Ring:
Resume on Time:
Resume Time:
SUS/RES Switch:
You may choose to Enable or Disable the
suspend function of the Suspend/Resume
Button. The resume function cannot
be disabled.
68
Smart Power Savings:
Smart Power Savings enables or disables the
ability of the power source to control the
power savings parameters. When the smart
function is enabled the power savings
features will not be active when a power
adapter is active.
Power Savings:
Power Savings sets the power savings para-
meters. You may choose to have no power
savings features, select a factory combination
of parameters for Maximum Performance,
select a factory combination of parameters
for Maximum Battery Life or you may choose
to customize the parameters to suit your
special operating needs. Settings for each set
of parameters are shown in Table 3-5.
Hard Disk Time-out:
The hard disk timeout parameter is the
length of time that the hard disk can be
inactive before your notebook automatically
turns o the power to the hard drive con-
troller and drive motor. If you choose a fac-
tory combination of parameters this field will
display the setting. If you choose to cus-
tomize the parameters you will be able to set
this yourself. The options available vary from
O , which has no inactivity shuto
from 30 seconds to 20 minutes.
Video Time-out:
The video timeout parameter is the length of
time without any user input d evice activity
before the display is turned o . If you choose
a factory combination of parameters,this
field will display the setting . If you choose to
customize the parameters, you will be able to
set this yourself. The options available vary
from O , which has no inactivity shuto , to
times from 30 seconds to 20 minutes.
Standby Time-out:
The standby timeout parameter is the length
of time without any user input device activity
before the processor clock is slowed to half-
speed putting the CPU in a lowered power
consumption condition and turning o the
display and the hard disk. If you choose a
factory combination of parameters this field
to times