How To Use Remote Controller - Toshiba MMK-AP0074MHP-E Owner's Manual

High-Wall Type
SMMS High-Wall Type
8.

How to Use Remote Controller

Cooling / heating / fan only
operation
Start
3
1
4
2
1
START / STOP button
Push this button to start the air conditioner.
2
Mode select button (MODE)
Select Cool
3
Temperature button (
Set the desired temperature.
When the air conditioner is in FAN ONLY operation,
the temperature display is not indicated.
4
Fan speed button (FAN)
Select one of
MED
HIGH
• The lamp (green) on the display panel of the
indoor unit goes on. And operation starts after
approximately 3 minutes.
(If you select FAN ONLY mode, the unit will start
immediately.)
• The : Fan only mode does not control
temperature.
Therefore, perform only steps
select this mode.
Stop
START / STOP button
Push this button again to stop the air conditioner.
17-EN
PRESET
START/STOP
FAN MODE AUTO
SWING ECO Hi-POWER
TIMER
MEMO
FIX
ON OFF SET CLR
FILTER
RESET CLOCK CHECK
, Heat , or Fan only
)
+
, LOW , LOW
+
, MED ,
.
1 2
, and
NOTE
When the indoor unit is operated together with a
cooling only outdoor unit,
remote controller but the heating operation is
disabled.
Dry operation
Start
3
1
2
.
1
START / STOP button
Push this button to start the air conditioner.
2
Mode select button (MODE)
,
Select DRY
3
Temperature button (
Set the desired temperature.
• The fan speed display indicates
• The
indoor unit lights, and operation starts after
approximately 3 minutes.
Stop
4
to
START / STOP button
Push this button again to stop the air conditioner.
– 17 –
(Heat) appears on the
PRESET
START/STOP
FAN MODE
SWING ECO Hi-POWER
TIMER
MEMO
FIX
ON OFF SET
FILTER
RESET CLOCK CHECK
.
)
lamp (green) on the display panel of the
Owner's Manual
AUTO
CLR