Warning Displays - FujiFilm FINEPIX S602 ZOOM Owner's Manual

Warning Displays

Warning Displayed
(Lit red)
(Blinking red)
ＦＩＬＥ ＮＯ．ＦＵＬＬ
ＰＲＯＴＥＣＴＥＤ ＦＲＡＭＥ
Aperture/Shutter speed display
(Lit red)
84
eThe table below lists the warnings that are displayed on the LCD monitor
Explanation
The camera batteries are low
on charge.
No media is inserted.
i The media is not formatted
(initialized).
i The SmartMedia contact area
(gold-colored area) is dirty.
i The camera is faulty.
i The SmartMedia is not loaded
correctly.
i The SmartMedia contact area
(gold-colored area) is dirty.
i The media is damaged.
i The media format is incorrect.
i The camera is faulty.
The media is full and no further
data can be recorded.
The SmartMedia is write-
protected.
i You attempted to play back
file that was not recorded
correctly.
i The SmartMedia contact area
(gold-colored area) is dirty.
i The camera is faulty.
i You attempted to play back a
voice file that was recorded
on a FinePix 50i.
Frame number 999-9999 has
been reached.
i Data cannot be recorded due
to a media fault or a problem
with the connection between
the media and the camera.
i The image you just shot is too
large to fit in the space
available on the media.
i The voice memo file is faulty.
i The camera is faulty.
There is a strong likelihood of
camera shake because the
shutter speed is slow.
You attempted to erase a
protected frame.
The AF (auto focus) doesn't
work very well.
Outside the AE continuous
range.
Remedy
Have spare batteries ready or replace the
batteries.
i Load a SmartMedia (3.3V) in the correct
direction.
i Load a Microdrive in the correct direction.
i Format the media.
i Wipe the SmartMedia contact area with a
soft, dry cloth. It may also be necessary to
format the SmartMedia. If an error message
still appears, replace the SmartMedia.
i Contact your FUJIFILM dealer.
i Push the SmartMedia all the way into the
slot and check that it is locked into place.
i Wipe the SmartMedia contact area with a
soft, dry cloth. It may also be necessary to
format the SmartMedia. If an error message
still appears, replace the SmartMedia.
i Contact your FUJIFILM dealer.
Erase some images or use a media that has
some available space.
Use a SmartMedia that is not write-protected.
i That data cannot be played back.
i Wipe the SmartMedia contact area with a
soft, dry cloth. It may also be necessary to
format the SmartMedia. If an error message
still appears, replace the SmartMedia.
i Contact your FUJIFILM dealer.
i That data cannot be played back.
Use a formatted SmartMedia to take pictures.
i Reload the media or switch the camera off
and then on again. If this does not remedy
the problem, contact your FUJIFILM dealer.
i Use a new media.
i The voice memo cannot be played back.
i Contact your FUJIFILM dealer.
Use flash photography. However, a tripod
should be used for some scenes and modes.
Protected frames cannot be erased. Remove
the protection using the camera on which the
protection was applied.
i If the subject is too dark, take the shot at a
distance of roughly 2 meters from the subject.
i Use AF lock to take the picture.
The shot can be taken, but the exposure will
not be correct.