Notes On The Media (Smartmedia™ And Microdrives) - FujiFilm FINEPIX S602 ZOOM Owner's Manual

Notes on the Media (SmartMedia
SmartMedia
The SmartMedia card is a new image recording medium
developed especially for use in digital cameras. Each
SmartMedia card contains a built-in semiconductor memory
chip (NAND flash memory) which is used for storing image
data files in digital form.
Because the data is stored electronically, the stored image
data can be erased from the card and new data recorded.
SmartMedia with ID
A SmartMedia with ID is a SmartMedia that has an
individually assigned identification number. SmartMedia ID
cards can be used with devices that use ID numbers for
copyright protection or other purposes. This camera accepts
SmartMedia ID cards in the same way as conventional
SmartMedia cards.
Microdrives
Microdrives are compact, lightweight hard disk drives that
conform to the CF+ Type II standard. Due to their ample
capacity for large image data files and their low per-
megabyte recording cost, Microdrives provide a more
economical way to save high-resolution image files.
Storing Data
In the situations listed below, recorded data may be erased
(destroyed). Please note that FUJIFILM accepts no
responsibility whatsoever for the loss (destruction) of
recorded data.
When the media is used incorrectly by the owner or a third
party
When the media is exposed to static electricity or electrical
noise
When the media is removed or the camera is switched off
during data recording or erasing (media formatting)
When the media is bent, dropped or otherwise subjected
to a strong force or impact
Important data should be backed up onto another medium.
(MO disk, floppy disk, hard disk, etc.)
General Notes on Handling Media (all types)
h When inserting the media into the camera, hold the media
straight as you push it in.
h Never remove the media or switch the camera off during
data recording or erasing (media formatting) as this could
result in damage to the media.
h Data storage media are precision electronic devices. Do
not bend, drop or otherwise subject the media to strong
force or shocks.
h Do not use or store these media in environments likely to
be affected by strong static electricity or electrical noise.
h Do not use or store media in locations subject to high
temperatures and humidity or in environments where they
are exposed to corrosive substances.
Notes on Handling SmartMedia
h Use only the SmartMedia specified for use with the
camera. The use of other SmartMedia could damage the
camera.
h Take care not to touch the SmartMedia's contact area (the
gold-colored area) or allow the area to become soiled. Use
a soft, dry cloth to wipe off any soiling that does occur.
h To avoid damage caused by static electricity, always use
the special static-free case provided when carrying or
storing the media. Alternatively, keep the SmartMedia in a
storage case if available.
h Inserting a SmartMedia that is charged with static
electricity into your camera may result in a camera
malfunction. If this occurs, switch the camera off and then
on again.
h Do not carry SmartMedia in locations such as a trouser
pocket. This could subject the SmartMedia to excessive
force when you sit down, thereby damaging the
™ and Microdrives)
SmartMedia.
h The SmartMedia may feel warm when it is removed from
the camera after extended periods of use. This is normal
and does not indicate a fault.
h SmartMedia have a limited life and it may become
impossible to record or erase data on a SmartMedia that
has been used for a long time. When this happens,
purchase a new SmartMedia.
h Affix the index labels supplied with the SmartMedia onto
the designated area of the card. Do not use third-party
labels as this can lead to problems when the card is
inserted or removed.
h When you attach the index label to a SmartMedia, take
care that it does not cover any part of the write-protect
area.
Notes on using Microdrive
h Do not write on the Microdrive label.
h Do not peel off the Microdrive label.
h Do not stick additional labels onto a Microdrive.
h When carrying or storing a Microdrive, keep it in the
protective case provided.
h Do not use Microdrive in CF+ Type II slots that do not
have an eject function.
h Take care when handling Microdrive that have been used
for long periods as they may become hot.
h Do not place Microdrive close to strong magnetic fields.
h Keep Microdrive dry.
h Do not apply strong pressure to the Microdrive cover.
Notes on using media with a computer
h If you intend to take photos using a media that has been
used on a personal computer, first format the media on
your camera.
h When you format a media in the camera and then
photograph and record images, a folder is automatically
created on the media. Image data is then recorded in this
folder.
h Do not change or delete the folder names or file names on
the media from your computer as this will make it
impossible to use the media in your camera.
h Always use the camera to erase image data on a media.
h To edit image data, copy the image data to the computer's
hard disk and then edit the copied data.
SmartMedia Specifications
Type Image memory card for digital cameras
(SmartMedia)
Operating voltage 3.3V
Conditions for use Temperature:
0°C to +40°C (+32°F to +104°F)
Humidity:
80% or less (no condensation)
Dimensions 37 mm
(1.45 in.
45 mm 0.76 mm
1.77 in. 0.03 in.) (W H
83
D)