Configure The Dge; Ethernet Setup - Crestron DGE-100 Supplemental Manual

Digital graphics engines

Hide thumbs Also See for DGE-100:

Table of Contents

Configure the DGE

On the main setup screen, tap Ethernet Setup to display the Ethernet Setup screen.

Ethernet Setup Screen

The Ethernet Setup screen displays the DGE's MAC and IP addresses, subnet mask,

default router, primary and secondary DNS, hostname, and domain. There are controls for

turning DHCP on and off, and when DHCP is off, a Set Static IP Address Settings button

provides access to controls that allow editing of these settings. This screen also contains a

link indicator to show the status of the Ethernet connection.

DHCP is enabled by default. To change to a static IP address, tap Off under DHCP

Enabled, and then tap Set Static IP Address Settings to display the Ethernet Setup -

Static IPs screen.

Ethernet Setup - Static IPs Screen

To edit the static IP address, static subnet mask, static default router, preferred DNS, or

alternate preferred DNS, tap the button directly under the label for the entry to edit. The on-

screen numeric keypad opens.

2 • DGE-100/DM-DGE-200-C: Digital Graphics Engines

Supplemental Guide – DOC. 7696B

Table of Contents

Dm-dge-200-c