Table of Contents
Advertisement
Maintenance
Disposing of Batteries
Making Sure Batteries
are Ready for Use
14
To condition a battery:
1. Insert the battery in the charging/conditioning slot as shown in Figure 12.
2. Press the conditioning button within 2 seconds after inserting the battery.
The indicator lights YELLOW to indicate the battery is being conditioned.
3. When the conditioning cycle ends, the Conditioning Status Indicator will
glow green.
Conditioning leaves the battery in a charged state.
To help protect the environment, C960SL rechargeable batteries which have
reached the end of their useful life should be disposed of in accordance with
local requirements.
Follow these tips to make sure batteries are always ready for use:
•
Have at least one extra battery for each belt pack. This helps ensure that a
fully charged battery is always available.
•
Recharge a low battery as soon as it is removed from the transceiver pack.
•
Keep the battery contacts clean: both those on the battery and those in the
belt pack. To clean the contacts, use an alcohol-moistened cotton swab.
•
Remember that a battery recharge takes approximately 1-1/2 to 2 hours.
•
Avoid removing and reinserting batteries while they are charging
(charging status indicator is RED).
•
Remember that batteries discharge fastest during Talk and Page operation.
Avoid unnecessary communications.
Note
Figure 12.
Model C960SL
3M 2003
Advertisement
Table of Contents
