Pioneer DEH-S5200BT Operation Manual page 46

Removing the unit (installed with the
supplied mounting sleeve)
1 Remove the trim ring.
CDTrim ring
® Notched tab
• Releasing the front panel allows easier
access to the trim ring.
, When reattaching the trim ring, point
the side with the notched tab down.
2 Insert the supplied extraction keys
into both sides of the unit until they
click into place.
3 Pull the unit out of the dashboard.
To secure the front panel
The front panel can be secured with the
supplied screw.
~ (j) Sc,ew
The microphone should be placed directly
in front of the driver at a suitable distance to
pick up their voice clearly.
AcAu110N
It is extremely dangerous to allow the
microphone lead to become wound around
the steering column or shift lever. Be sure to
install the microphone in such a way that it
will not obstruct driving. It is recommended
to use the clamps (sold separately) to
arrange the lead.
NOTE
Depending on the vehicle model, the
microphone cable length may be too
short when you mount the microphone
on the sun visor. In such cases, install the
microphone on the steering column.
To install on the sun visor
1 Fit the microphone lead into the
groove.
CD Microphone
lead
® Groove
2
Install the microphone clip on the sun
visor.
Lowering the sun visor reduces the voice
recognition rate.
CD Microphone clip
To install on the steering
column
1 Slide the microphone base to detach
it from the microphone clip.
CD Microphone
® Microphone clip
@ Microphone base
2 Install the microphone on the rear
side of the steering column.
CD Double-sided tape