Pioneer DEH-S5200BT Operation Manual page 44

I
To
power cord input
2, Front left speaker
l
Front right speaker
©
Rear left speaker
®
Rear right speaker
s.
White
1
White/black
EGray
® Gray/black
@ Green
J.l Green/black
@ Violet
@Violet/black
.14, Black (chassis ground)
Connect to a clean, paint-free metal
location.
® Yellow
Connect to the constant 12 V supply
terminal.
@ Red
Connect to terminal controlled by the
ignition switch (12 V DC).
1J
Blue/white
Connect to the system control terminal
of the power amp or auto-antenna relay
control terminal (max. 300 mA 12 V DC).
i§.
Subwoofer (4 0)
@) When using a subwoofer of 2 0, be sure
to connect the subwoofer to the violet
and violet/black leads of this unit. Do not
connect anything to the green and green/
black leads.
® Not used.
~ Subwoofer (4 0) x 2
@ Orange/white (Only for DEH-55200BT)
Connect to a car's illumination signal.
Power amp (sold separately)
Perform these connections when using the
optional amplifier.
DEH-55200BT
DEH-54220BT/54200BT
1 ~ -
®
(J)
@
Q) ~ 2
~ i
(ft
@
®
lt
e e
T
System remote control
Connect to blue/white cable.
@ Power amp (sold separately)
1
Connect with RCA cables (sold separately)
© To rear output
~
Rear speaker
@ To front output
'1'
Front speaker
~
To subwoofer output
® Subwoofer
®
To rear output or subwoofer output
·1_1,,
Rear speaker or subwoofer
~Important
• Check all connections and systems before
final installation.
• Do not use unauthorized parts as this may
cause malfunctions.
• Consult your dealer if installation requires
drilling of holes or other modifications to
the vehicle.
• Do not install this unit where:
-it may interfere with operation of the
vehicle .
-it may cause injury to a passenger as a
result of a sudden stop.
• Install this unit away from hot places such
as near the heater outlet.
• Optimum performance is
obtained when the unit is
installed at an angle of less
than 60°.
• When installing, to ensure proper heat
dispersal when using this unit, make sure
you leave ample space behind the rear
panel and wrap any loose cables so they
are not blocking the vents.
Leave ampl
space
DIN mount installation
1 Insert the supplied mounting sleeve
into the dashboard.
2 Secure the mounting sleeve by using
a screwdriver to bend the metal tabs
(90°) into place.
Q) Dashboard
2, Mounting sleeve
• Make sure that the unit is installed
securely in place. An unstable
installation may cause skipping or other
malfunctions.
When not using the supplied
mounting sleeve
1 Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
• •·
2 Tighten the screws on each side.
Q) Screw
@ Mounting bracket
@ Dashboard or console
• Use either truss (5 mm
x
9 mm) or
flush surface (S mm x 9 mm) screws,
depending on the bracket screw holes.