Assemble The Speed Control Rod And Speed Select Lever - Sears CRAFTSMAN C950-52871-0 Owner's Manual

ASSEMBLE THE SPEED CONTROL ROD
AND SPEED SELECT LEVER
1. Assemble the speed select lever (A, Figure 5) to the speed
control rod using screw and nut.
2. Attach the ball joint (B, Figure 6), located on the bottom end
of the speed control rod (A), to the shift yoke assembly (F).
3. The length of the ball joint
pre-adjusted at the factory.
a. If an adjustment is required, loosen the nut (C). Remove
the washer (D) and nut (E) to disconnect the ball joint
from the shift yoke assembly (F).
b. To lengthen or shorten the speed control rod, turn the
ball joint to obtain the correct length.
4. Make sure the speed select lever (A, Figure 5) functions cor-
rectly. Move the speed select lever through all speeds.
5. Attach the knob (B) for the remote deflector control.
ASSEMBLY
a d n speed control rod have been
A A
C
B
12
A
B
(see Figure 6)
Figure 5
E
D
F
Figure 6