Connect Control Cable Springs; Shifter Lever Knob Assembly - Sears Craftsman C950-52009-0 Owner's Manual

ASSEMBLY
CONNECT CONTROL CABLE SPRINGS
1. If control cable springs have become unattached from
motor mount frame, reconnect cables as shown in
Figure 8.
2. For cable adjustments, see "Cable Adjustment" in the
ADJUSTMENT/REPAIR section.
HOW TO SET
THE LENGTH OF THE CABLES
The cables were adjusted at the factory and no adjustments
should be necessary. However, after the handles are put in
the operating position, the cables can be too tight or too
loose. If an adjustment is necessary, see "How To Check And
Adjust The Cables" in the Service And Adjustment section.
Figure 8
SHIFTER LEVER KNOB ASSEMBLY
1. Thread the hex nut found in the parts bag onto shifter le-
ver. (See Figure 9)
2. Thread the shifter lever knob onto the threaded end of
the shifter lever until it is snug against the hex nut and the
lip is pointed away from the engine.
3. Tighten hex nut against the bottom of the shifter lever
knob.
\
\
\
\
\\
Shifter Lever
Hex Nut
Figure 9
I
F_01136J
NOTE: This snow blower was shipped WITH OIL in the engine. See "Before Starting Engine" in-
structions in the Operation section of this manual before starting engine,
10