Table of Contents
Advertisement
3.3
Change over panel
POWER
DISPLAYED TEXT
1-GYRO:142.7° SA*
2-GYRO:142.7° SA*
E-SENS:141.9
HDM SET:05.0°
- PARAMETER SET -
< ALARMS >
9
This panel is used to toggle between available compasses, to display
bearing for the Gyro compasses, and to display alarm information. The
panel is also used to set the alarm difference limit.
The panel includes the buttons described on the following pages.
POWER button
Used to turn the Dual control panel ON.
The button is recessed into the front panel, and a pen or a blunt tool must
be used to activate the button.
Display
The LCD displays data in 2 rows, where each row has 16 characters
available. The figure below shows the display after the start-up procedure
is completed.
1-GYRO:142.7° *A
2-GYRO:142.7°
When pressing the DISP button, the display will page through available
data and eventually alarm lines as shown below:
Heading for Gyro number 1.
Heading for Gyro number 2.
Heading for external sensor. Only visible when an external sensor is
connected.
Setting for heading difference alarm.
Used for entering the parameter setup submenu
Visible if 1 or more alarms are generated. Refer Alarm messages on
the Change over panel, page 26.
DESCPRIPTION
S
= Less than 2 hours
since the Gyro was
started
A
= For internal use
*
= Active Gyro
USER INTERFACE
988-12720-002
Advertisement
Table of Contents
