Kenwood DDX6906S Instruction Manual page 72

Controlling Audio
Speaker / X'over setup
1
Press the [ ]/[MENU] button.
h Popup menu appears. h
2
Touch [Audio].
h Audio screen appears. h
3
Touch [Speaker / Xʼover].
4
Select a car type.
You can select the car type and speaker
network, etc.
When you select your car type, the Delay
Time Alignment is activated automatically (for
timing adjustment of sound output for each
channel) to have the highest surround effects.
5
Touch the speaker (1) you wish to adjust
and set each parameter (2) as follows.
1
■ [Speaker]
You can select a speaker type and its size to
get the best sound effects.
When the speaker type and size are selected,
the speaker crossover network is set
automatically.
[Location] (Only for Front, Rear)
■
Select the speaker position you have
installed.
[Tweeter] (Only for Front)
■
You can set up the tweeter when you are
selecting front speakers.
None, Small, Medium, Large
72
2
■ [Xʼover]*
Display the speaker crossover setup screen.
You can adjust the crossover frequency that
was set automatically when you selected the
speaker type.
For details, see Crossover network setup
(P.72)
* Only when "Speaker" is set to a mode other
than "None".
When Speaker network is set to 3-way:
1
NOTE
• For how to switch to the 3-way speaker system,
see 3-way speaker system setup (P.71).
Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
• Select "None" if you have no speakers.
Ñ
Crossover network setup
You can set the crossover frequency of
speakers.
1
Touch [Xʼover].
2
Touch the speaker to set up.
2