Kenwood DDX6906S Instruction Manual page 71

Controlling Audio
You can adjust various settings such as audio
balance or subwoofer level.
1
Press the [ ]/[MENU] button.
h Popup menu appears. h
2
Touch [Audio].
See the following section for each
setting.
• Set up speaker / X'over (P.72)
• Controlling equalizer/ subwoofer level
(P.74)
• Set listening position / DTA (P.77)
• Controlling general audio (Fader /
Balance) (P.73)
• Set volume offset (P.75)
• Performing zone control (P.75)
• Set sound effect (P.76)
• Memory/recall the audio settings
(P.78)
3-way speaker system setup
(DDX6906S/ DMX706S)
Select the appropriate crossover network
mode for the speaker system used (2-way or
3-way speaker system).
1
Press the [ ]/[HOME] button.
h HOME screen appears. h
2
Touch [
].
h Source selection screen appears. h
3
Touch [STANDBY].
4
Press the button 1 followed by the
button 2 for 1 second at the same time.
DDX6906S
2
1
DMX706S
1
h Speaker system select screen appears. h
5
Select the crossover network mode.
h A confirmation screen appears. h
6
Touch [Yes].
NOTE
• When the 3-way speaker system is selected, the
following functions are disabled.
– Front focus of Listening Position / DTA
– Fader for Controlling General Audio
– Zone Control
– Selection of the speakers to output sound from
the cell-phone of Bluetooth HF/Audio
– Beep for User Interface Setup
• Connecting 3-way speakers with the 2-way mode
selected can break the speakers.
Controlling Audio
2
71
English