Related Manuals for Kenwood DDX6036
Summary of Contents for Kenwood DDX6036
-
Page 1: Installation Manual
MONITOR WITH DVD RECEIVER DDX6036 DDX6036M INSTALLATION MANUAL © B54-4756-00 (MW/M2W) - Page 2 Accessories DDX6036/DDX6036M ...1 ...1 ...1 ...2 ...1 ...1 ...6 ...6 ...1...
-
Page 3: Installation Procedure
Installation Procedure 1. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. 2. Make the proper input and output wire connections for each unit. 3. Connect the speaker wires of the wiring harness. 4. - Page 4 Connect to the terminal that is grounded when either the telephone rings or during conversation. ⁄ To connect the Kenwood navigation system, consult your navigation manual. Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type antenna.
- Page 5 FUSE ( 15A ) REVERSE STEERING WHEEL REMOTE CONT REMOTE INPUT ILLUMI MUTE ANT. CONT P.CONT Cooling fan Accessory 1 White/Black White Gray/Black Gray Green/Black Green Purple/Black Purple To front left speaker To front right speaker To rear left speaker To rear right speaker English...
-
Page 6: System Connection
System Connection USB terminal DDX6036/DDX6036M USB device (commercially available) Audio input (iPod/AV Input 2 switchable) Resistance-free stereo type mini plug (3.5φ) Visual input (iPod/AV Input 2 switchable) Resistance-free mini plug (3.5φ) Accessory 3 Accessory Audio/Visual Output • Visual output (Yellow) •... -
Page 7: Optional Accessory Connection
(Included in the KCA-BT200) Navigation System (Optional Accessory) INPUT ANTENNA ⁄ Navigation units that can be connected to this unit. (As of December, 2009): ・ KNA-G630 ・ KNA-G630CN For latest information, access the www.kenwood.com/cs/ce/. Connection cable (Included in the Navigation System) English... -
Page 8: Installing The Escutcheon
Cut out to meet the shape of the opening in the vehicle. For Volkswagen 1. Attach accessory 9 to the unit. DDX6036/DDX6036M For Toyota/Scion 1. Cut out accessory 5 as illustrated. Accessory 5 2. Fold double-sided adhesive (accessory 6) along the slit and attach it to accessory 5 cut-out against the center rib as illustrated. -
Page 9: Installation For Monitor/Player Unit
Installation for Monitor/Player Unit ⁄ Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 7 (M5x6mm) or Accessory 8 (M5x7mm) Car Bracket Bend the tabs of the mounting... -
Page 10: Removing The Unit
• The frame can be removed from the top side in the same manner. 2. When the lower level is removed, remove the upper two locations. DDX6036/DDX6036M Removing the Unit 1. Remove the hard rubber frame by referring to the removal procedure in the section <Removing the Hard Rubber Frame>.