Connecting Cables; Connecting Data Cables - Supero SUPERSERVER 2027TR-HTQRF User Manual

SUPERSERVER 2027TR-HTQRF/HTFRF/HTRF USER'S MANUAL
5-2

Connecting Cables

Now that the processors are installed, the next step is to connect the cables to
the serverboard.

Connecting Data Cables

The cables used to transfer data from the peripheral devices have been carefully
routed in preconfi gured systems to prevent them from blocking the fl ow of cooling
air that moves through the system from front to back. If you need to disconnect
any of these cables, you should take care to reroute them as they were originally
after reconnecting them (make sure the red wires connect to the pin 1 locations). If
you are confi guring the system, keep the airfl ow in mind when routing the cables.
Only two (2) SATA cables (i-SATA 0/1) are connected. See the serverboard layout
diagram in this chapter for connector locations.
5-2