LG 55EW960H Commercial Mode Setup Manual page 57

Configuring a Wired Network Connection
Note: If desired, you can configure both wired and wireless
connections. However, note that a wired connection is always
prioritized over a wireless connection. That is, when the TV is
turned OFF and then back ON, if a LAN cable is detected between
the TV and the network, the TV will default to the wired connection.
If the LAN cable is removed, the TV will then attempt to establish
the wireless connection. Whenever the LAN cable is reconnected,
the TV will re-establish the wired connection.
1. Connect the appropriate cable between the TV and the network.
2. With the Network Menu on display, use the arrow keys on the
Installer Remote to select Network Setting. Then, press the
Wheel (OK) button. A second Network screen (see example at
right), with Wired and Wi-Fi Connection setup options, will be
displayed.
By default, the TV uses DHCP, and if a LAN cable is detected,
the TV will attempt to connect to the network as soon as you
select "Network Setting" above. If the TV is able to connect to
the network, a "Connected to Internet" message will be displayed
below the Wired Connection field.
3. If the network is not configured for DHCP or you want to specify
static configuration data or you would like to change the network
configuration from Manual to Automatic, edit the IP configuration
for this TV as follows:
• In the second Network screen, select Wired Connection and
press the Wheel (OK) button. Then, in the Wired screen, select
Edit (if not already selected) and press the Wheel (OK) button.
• In the Edit IP screen, select or de-select the "Set Automatically"
checkbox, as required. A checkmark indicates that Automatic
configuration is enabled.
• To manually edit the IP configuration, for each data entry field:
Use the arrow keys on the Installer Remote to select the field
and press the Wheel (OK) button. You can use the number
keys on the Installer Remote to direct enter numeric values or
use the arrow keys to select the appropriate numbers from the
pop-up virtual keyboard displayed at the bottom of the screen.
(Note, however, that you must use the dot "." key from the
virtual keyboard to separate each octet of an IP address.) When
you are done, select Enter from the virtual keyboard, and then
press the Wheel (OK) button on the Installer Remote.
• When all Edit IP fields are set as required, use the arrow keys
on the Installer Remote to select Connect and press the
Wheel (OK) button.
At the top of the screen, you will see a progress display that
indicates status as each network element is confirmed (see
example at right).
206-4307
IP Environment Setup (Cont.)
NETWORK SETT...
Network
Network /
Pro:Centric
Wired Connection (Ethernet)
Not Connected
Media Share
Wi-Fi Connection
Not Connected
Pre-loaded
Apps
WIRED
Network
Network / Network Setting /
Pro:Centric
Connected to Internet
Media Share
IP (Automatic)
IP Address
Pre-loaded
Apps
Subnet Mask
Gateway
DNS Server
MAC Address
EDIT IP
Network
Network / Network Setting / Wired Connection (...
Pro:Centric
Connected to Internet
Media Share
Set Automatically
IP Address
Pre-loaded
Apps
Subnet Mask
Gateway
DNS Server
DNS
10.1.2.4
255.255.255.0
10.1.2.3
10.1.2.3
C8:08:E9:40:49:F5
EDIT
DNS
10.1.2.4
255.255.255.0
10.1.2.3
10.1.2.3
CONNECT
(Continued on next page)
57