Clock; Timer - Philips FW-P78 Manual

All manuals and user guides at all-guides.com

CLOCK

MINI HIFI SYSTEM
PROGRAM SHUFFLE
REPEAT

TIMER

REC
NEWS T.A. AM MW FM LW
60Hz 250Hz 500Hz
1KHz
STANDBY
ON
CLOCK/
CD1 • 2 • 3 BAND
TIMER
CD TUNER
PROG
SEARCH • TUNING STOP • CLEAR
SOUND NAVIGATION
DIGITAL SOUND
CONTROL
View Clock
You can view the clock (if it is set) if the
system is in Standby mode or when any
sound source is selected (CD, TUNER, etc.).
The clock will be displayed for about 7
seconds.
• Press CLOCK/TIMER briefly.
™ "PM 10:38 or 22:38" (the
current time) will be displayed
depending on whether you have
selected 12- or 24-hour mode.
™ "--: : : : : --" will be displayed if the
clock is not set.
Note:
– When the system goes into low power
standby mode, the clock setting will not
be displayed (for model FW-P78 only).
26
pg 01-31/P75-P78/34-Eng 26
5 Press CLOCK/TIMER again to store the
C
STEREO
L R
BACK
FRONT HSD
PRO LOGIC
2KHz 4KHz 8KHz
S S
DOLBY B
• To exit without storing the setting, press
NR
RDS
RDS
NEWS/TA NEWS!
TAPE 1 • 2 CDR / VIDEO
Notes:
TAPE AUX
– During clock setting, if no button is
SIDE A•B PRESET A.REV
PLAY PAUSE PREV SIDE NEXT
MIC
LEVEL
DYNAMIC BASS
MIC
BOOST
– When a power interruption occurs, the
– To set the time with RDS clock, see
Clock Setting
The clock can be set in either 12- or 24-
hour mode, e.g. "AM 12:00" or
"00:00". Before setting the clock, you
must be in the View Clock mode.
1 Press CLOCK/TIMER to select clock
mode.
2 Press PROG (on the system only) to
select 12- and 24- hour mode.
™ If 12-hour mode is selected,
"AM 12:00" starts flashing.
™ If 24-hour mode is selected,
"00:00" starts flashing.
3 Set the hour with à or á on the
system.
4 Set the minute with í or ë on the
system.
TIMER
Timer Setting
setting.
• The system can switch on to CD,
™ The clock starts.
TUNER, or TAPE 2 mode automatically
at a preset time. It can serve as an
Ç on the system
alarm to wake you up.
• Before setting the timer, make sure the
clock is set correctly.
• The timer will always be switched on
pressed within 90 seconds, the system
once it is set.
will exit clock setting mode
• The volume of the timer will
automatically.
increase from the minimum level
until the volume level before the set
clock setting is erased.
is switched to standby mode.
"Receiving RDS Radio Station" under
1 Press and hold CLOCK/TIMER for more
TUNER section (for model FW-P78 only).
than 2 seconds to select timer mode.
™ " AM 12:00" or "00:00" or the
last timer setting starts flashing
depending on whether you have
selected 12- or 24-hour mode.
™ The
™ The selected source is lit while other
available sources are flashing.
2 Press CD, TUNER or TAPE to select the
desired source.
• Before selecting CD or TAPE, make sure
a CD or tape is loaded in the CD tray or
tape deck 2.
3 Press à or á on the system to set
the hour for the timer to start.
4 Press í or ë on the system to set the
minute for the timer to start.
2/22/00, 7:30 PM
starts flashing.
TIMER
3139 116 19561