Modem - Toshiba Satellite Pro A300D Series User Manual

Modem

Problem
Communication
software can't initialize
modem
You can hear a dial tone
but can't make a call
You place a call, but a
connection can't be
made
After making a call you
can't hear a ring
Communication is cut
off unexpectedly
A CONNECT display is
quickly replaced by NO
CARRIER
Character display
becomes garbled during
a communication
You cannot receive an
incoming call
User's Manual
Procedure
Make sure the computer's internal modem
settings are correct. Refer to Phone and Modem
Options in the Control Panel.
If the call is going through a PBX machine, make
sure the communication application's tone dial
detection feature is disabled.
You can also use the ATX command.
Make sure the settings are correct in your
communications application.
Make sure the tone or pulse selection in your
communications application is set correctly.
You can also use the ATD command. Refer to the
chapter on AT commands in online help files for
Appendix C, AT Command.
The computer will automatically cut off
communication when connection with the carrier
is not successful for a set time interval. Try
lengthening this time interval.
Check the error control setting in your
communications application.
You can also use the AT\N command.
In data transmission, make sure the parity bit and
stop bit settings correspond with those of the
remote computer.
Check the flow control and communication
protocol.
Check the rings before auto answer setting in an
incoming call your communications application.
You can also use the ATS0 command.
If problems persist, contact your dealer.
Troubleshooting
9-17