[Save All User Data]; [Load All User Data]; [Initialize] - Panasonic PT-RZ120LBU7 Operating Instructions Manual

Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq

[SAVE ALL USER DATA]

Save the various setting values as a backup in the built-in memory of the projector.
1) Press as to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f [PROGRESS] is displayed while saving data.
Note
f Data set from the computer application is not included in [ALL USER DATA].
f The data saved by executing [SAVE ALL USER DATA] is not deleted even if the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL
USER DATA] is executed.

[LOAD ALL USER DATA]

Load the various setting values saved as a backup in the built-in memory of the projector.
1) Press as to select [LOAD ALL USER DATA].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
Note
f The projector enters the standby mode to reflect the setting values when [LOAD ALL USER DATA] is executed.
f Data registered from a computer is not included in [ALL USER DATA].

[INITIALIZE]

Return various setting values to their factory default settings.
1) Press as to select [INITIALIZE].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The [INITIALIZE] screen is displayed.
4) Press as to select an item to initialize.
[ALL USER DATA]
[REGISTERED SIGNAL]
[NETWORK/E-MAIL]
[LOGO IMAGE]
146 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns all setting values including [REGISTERED SIGNAL], [NETWORK/E-MAIL], and [LOGO
IMAGE] to the factory default settings.
The projector enters the standby mode to reflect the setting values.
Deletes all the setting values saved for each input signal.
To delete only a part of a registered signal, perform the procedure described in "Deleting the
registered signal" (x page 149).
Returns the setting of the [NETWORK] menu → [NETWORK SETUP] and the setting of "[E-mail set
up] page" (x page 174) in the web control screen to the factory default settings.
Deletes the image registered in [USER LOGO].