[Input Resolution]; [Clamp Position]; [Edge Blending] - Panasonic PT-RZ120LBU7 Operating Instructions Manual

Blanking correction
Left side of the
screen
Right side of the
screen
Note
f The upper limit of the adjustment range may be restricted so that the entire projected image is not covered by blanking width.

[INPUT RESOLUTION]

You can adjust the image to achieve an optimal image when there is a flickering image or smeared outlines.
1) Press as to select [INPUT RESOLUTION].
2) Press the <ENTER> button.
f The [INPUT RESOLUTION] screen is displayed.
3) Press as to select [TOTAL DOTS], [DISPLAY DOTS], [TOTAL LINES], or [DISPLAY LINES], and press
qw to adjust each item.
f Values corresponding to the signal being input are displayed automatically for each item. Increase or
decrease the displayed values and adjust to the optimal point while viewing the screen if there are vertical
stripes or sections are missing from the screen.
Note
f Previously mentioned vertical banding will not occur with all white signal input.
f Image may be disrupted during automatic adjustment, but this is not a malfunction.
f [INPUT RESOLUTION] can be adjusted only when RGB signal or YC
IN> terminal.
f Adjustment may not be possible depending on the signal.

[CLAMP POSITION]

You can adjust the optimal point when the black part of the image is blunt or it has turned green.
1) Press as to select [CLAMP POSITION].
2) Press qw to adjust.
Status
The black part is blunt.
The black part is green.
Note
f [CLAMP POSITION] can be adjusted only when a signal is input to the <RGB 1 IN> terminal or the <RGB 2 IN> terminal.
f Adjustment may not be possible depending on the signal.

[EDGE BLENDING]

The edge blending function allows multiple images to be seamlessly overlapped by using the inclination of the
brightness at the overlapped area.
1) Press as to select [EDGE BLENDING].
100 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Item Operation
Press w.
[LEFT]
Press q.
Press q.
[RIGHT]
Press w.
Rough guide for optimal value
The point where bluntness of the black part improves the most is
the optimal value.
The point where the green part becomes black, and the bluntness
has improved is the optimal value.
Adjustment
The blanking zone
moves to the right.
The blanking zone
moves to the left.
The blanking zone
moves to the right.
The blanking zone
moves to the left.
C /YP P signal is input to the <RGB 1 IN> terminal or the <RGB 2
B R B R
Range of adjustment
Left and right 0 - 1 918
Range of adjustment
1 - 255