Panasonic AW-HN40HKPJ Operating Instructions Manual page 11

How to install and connect the unit
6
Connect the rear panel connectors.
Anchor the AC adaptor cable in place using the cable clamp.
Note
● Always disconnect the power supply before connecting or disconnecting cables.
Connecting or disconnecting cables while the power is turned on may result in malfunctions.
The unit is in the standby condition when the AC adaptor is connected.
The primary circuit is always "live" as long as the AC adaptor is connected to an electrical outlet.
(continued)
AC adaptor cable
LAN cable
HDMI cable
(for RS-422)
●
How to secure the AC
adaptor cable
 Loosely secure the cable
clamp.
LAN cable
RS-232C cable
Loosely secure the cable clamp in
the area shown above.
 Fasten the cable clamp.
Take hold of the strap part, slide
the cable clamp until it stops
moving, and then secure it tightly.
Cable clamp
Strap part
11