Grizzly G0835 Manual page 42

20. Use (2) M12-1.75 x 20 cap screws, (2)
12mm flat washers, and (2) 12mm lock
washers to install tool rack at end of lathe bed
(see Figure 24).
Tool Rack
Figure 24. Tool rack mounted at end of bed.
Note: The tool rack can also be installed on
the front of the lathe bed (see Figure 25)
using the same fasteners listed above.
x 2
Figure 25. Tool rest mounted on front of bed.
Model G0799 G0800 (Mfd. Since 11/17)
21. Locate pre-installed lower hinge, hinge pin,
x 2
Tool
Rack
and brass washer (see Figure 26) at end of
lathe bed. Mount swing-away bed by lower-
ing upper hinge onto hinge pin (see Figure
27). Leave M6-1 x 10 set screws loose for
now.
Hinge Pin
Brass
Washer
Lower
Hinge
Figure 26. Lower hinge, hinge pin, and brass
washer for mounting swing-away bed.
Swing-Away Bed
Hinge Pin
Upper
Hinge
Figure 27. Swing-away bed hinge assembled.
Lathe Bed
Set Screws
-25-