Table of Contents
Advertisement
4.
Loosen tailstock lock lever (see Figure 17)
and move tailstock to end of bedway, then
retighten lock lever. This will help balance the
lifting load.
Figure 17. Location of tailstock lock lever.
5.
Loosen toolrest base lock lever and move
toolrest next to tailstock.
6.
To further balance load, loosen headstock
lock lever (see Figure 18) and move head-
stock to center of bedway.
Toolrest Base
Lock Lever
Figure 18. Location of headstock control lever.
Model G0799 G0800 (Mfd. Since 11/17)
7.
Tailstock
Lock Lever
8.
9.
10. If bolting lathe to floor, skip to Step 13.
Wrap lifting straps around bedway (see
Figure 19), with one strap at each end.
Straps should be positioned next to bedway
mounting points to maintain best balance.
Figure 19. Lifting lathe with straps properly
positioned.
Use a forklift and at least 2 other people to
carefully position lathe assembly on top of
legs.
Once mounting holes are aligned, secure
lathe assembly to legs with (8) M12-1.75 x 35
cap screws, as shown in Figure 20.
Figure 20. Securing lathe bedway to leg
assembly.
x 8
-23-
Advertisement
Table of Contents
