Grizzly G0835 Manual page 41

11. With lathe still supported by lifting straps, use
forklift to raise lathe 4 to 5 inches in prepara-
tion for installing machine feet (see Figure
21).
12. Remove top hex nut from feet, insert feet in
mounting holes in leg (see Figure 21), then
thread top hex nut back on. Do not tighten
hex nuts yet.
Figure 21. Machine lifted for feet installation.
13. Lower machine onto floor, place level on
lathe bed, and make necessary adjustments
so bed is level from side-to-side and front-to-
back. This process will help bedways remain
straight and flat.
Note: For best results, use a precision level
that is at least 12" long and sensitive
enough to show a distance movement
when a 0.003" shim (approximately the
thickness of one sheet of standard news-
paper) is placed under one end of the
level.
— If you are using machine feet, adjust top
and bottom hex nuts on each leg to level
bed; then tighten hex nuts to secure these
adjustments.
— If you are bolting lathe to floor, use shims
under legs to level bed; then tighten
mounting fasteners.
14. Tighten hex nuts installed on chisel pan
mounting rod in Step 3 so they are flush
against the inside of each leg. Then tighten
lock nuts to completely secure mounting rod.
-24-
15. Use (2) M10-1.5 x 30 cap screws, (2) 10mm
flat washers, and (2) 10mm lock washers to
attach the chuck guard mounting arm to the
back of the headstock (see Figure 22).
Cap Screws
Figure 22. Chuck guard mounting arm installed.
16. Loosen M6-1 x 8 set screw on chuck guard
outside lock collar and remove collar from
shaft (see Figure 23).
17. Loosen set screw on inside lock collar so col-
lar moves freely (see Figure 23).
18. Insert chuck guard shaft into arm, while lifting
spring pin. Gently rotate chuck guard until
spring pin settles into detent on shaft (see
Figure 23).
19. Slide both lock collars up against chuck
guard arm and tighten (see Figure 23).
Chuck Guard Arm
Inside Lock Collar
and Set Screw.
Figure 23. Chuck guard installed in mounting
arm.
Model G0799 G0800 (Mfd. Since 11/17)
Mounting Arm
Spring Pin
Outside Lock Collar
and Set Screw.