Intel 6 Series User Manual page 21

Getting Started
Make sure there are no warnings or errors.
12. From DOS, run the following to update the Keyboard and System Controller
flash:
o
Make sure there are no warnings or errors.
13. Power the system down by pressing the PWR button.
14. Clear the CMOS by performing the following:
a. Shunt the CMOS CLR jumper (J5F3 – near the on-board battery).
b. Press the PWR button on the board. The board will not power on, but a
15. Switch the power supply off to power down the board.
a. Remove the CMOS CLR jumper (J5F3).
16. Unplug the bootable USB key.
Verify Correct BIOS Installation:
1. Switch the power supply back on.
2. Press the PWR button on the board to power-up the system.
3. Boot to BIOS Configuration screen by pressing F2 at the BIOS splash screen.
4. In the BIOS Main screen, check that the "Project Version" lists the correct
version of the BIOS.
5. Press the PWR key on the board to power the system back down, or you may
simply exit the BIOS menu and continue booting into the operating system.
The system is now ready for normal operation.
March 2011
Document Number: 325208-001
kscupdate ksc.bin
couple of LEDs will flash.
nd ®
2 Generation Intel Core™ Processor with Intel
®
6 Series Chipset Development Kit
User Guide
21