Changing The Oil Filter - Toro TurfMaster 22207 Manual

76cm walk-behind lawn mower
Hide thumbs Also See for TurfMaster 22207:
Table of Contents

Advertisement

Available languages

Available languages

5.
After draining the used oil, return the machine to
the operating position.
6.
Carefully pour about 3/4 of the engine capacity
of oil into the oil-fill tube.
7.
Wait 3 minutes for the oil to settle in the engine.
8.
Wipe the dipstick clean with a clean cloth.
9.
Insert the dipstick into the oil-fill tube, then
remove the dipstick.
10.
Read the oil level on the dipstick
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8
through
10
is correct.
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11.
Install the dipstick securely.
12.
Recycle the used oil properly.

Changing the Oil Filter

Service Interval: Every 200 hours
1.
Run the engine to warm the oil.
2.
Shut off the engine and wait for all moving parts
to stop.
3.
Disconnect the wire from the spark plug.
4.
Drain the engine oil; refer to
Engine Oil (page
5.
Place a rag under the oil filter to catch any oil
that may leak out as you remove the filter.
Figure 27
(Figure
until the oil level on the dipstick
Changing the
22).
6.
Remove the oil filter
Note:
off with the filter.
g019648
1. Oil filter
7.
Use your finger to coat the gasket on the new
filter with oil
26).
1. Gasket
8.
Install the new filter until the gasket contacts
the filter base, then hand tighten the filter an
additional 2/3 turn.
9.
Fill the crankcase to the correct level on the
dipstick with fresh oil; refer to
Engine-Oil Level (page
10.
Connect the wire to the spark plug.
11.
Run the engine for about 3 minutes.
12.
Shut off the engine, wait for all moving parts to
stop, and check for oil leakage around the filter.
13.
Add oil to compensate for the oil in the oil filter;
refer to
14.
Recycle the used oil filter according to local
codes.
23
(Figure
28).
Make sure that the oil-filter gasket comes
Figure 28
(Figure
29).
Figure 29
11).
2 Adding Oil to the Engine (page 7)
g276457
g002805
Checking the

Advertisement

Table of Contents
loading

Table of Contents