Ke6940R (Receiver) Rear View - ATEN KE6900ST User Manual

KE6940R (Receiver) Rear View

1 2
6
5
No. Component
1 Grounding
Terminal
2 Reset
3 Audio Ports
4 USB Port
5 Power Jack
6 Function Switch
7 RS-232 Port
4
3
8
7
The wire used to ground the unit connects here.
This switch must be pushed with a thin object, such as the
end of a paper clip.
Press and release to reboot the device.
Power off, hold reset then power on the device
while pressing reset to recover from a firmware
upgrade failure.
Press and hold it in for more then three seconds
resets the unit back to its factory default settings.
These mini stereo ports are for the local speakers (green)
and microphone (pink).
Use this port for virtual media or a USB peripheral device.
Note: 1. When using a USB disk plugged into this port,
see USB Mode, page 177.
2. This USB port does not support isochronous
endpoints, therefore USB peripherals that
stream audio or video data, such as speakers or
webcams, will not work.
The cable from the DC Power adapter connects here.
Use this slide switch to set the unit's mode:
Extension: Sets the device to use the normal TX to RX
extension mode.
RS-232 Config: The device is ready to be configured
via serial commands through the RS-232 port.
This RS-232 serial port is for connecting to a serial
terminal.
9
Description
Chapter 1. Introduction
10
27