Agilent Technologies 11713B Operating And Service Manual page 82

7
Remote Interface Configurations
82
Manual Mode
In a manual mode, you must set up the IP Address, Subnet Mask
and Default Gateway that is compatible with your network
infrastructure. If it is not correctly setup, 11713B/C will not be
visible on your network.
To prepare 11713B/C for manual mode,
Step Action
1 Ensure your a Connect your computer to 11713B/C using CAT5 crossover cable
computer is
b Make sure power is applied to your computer and verify that the
connected to
operating system is fully booted
11713B/C
c Apply power to 11713B/C and background LED color turns red,
and turned
indicating standby mode.
on.
d Allow 11713B/C to warm up for 15 seconds, then press the ON
button (LED turn from red to green)
2 Verify a Press Menu/Enter
11713B/C button on the front
LAN panel of 11713B/C
configuration
b Select IO using
is ready for
navigation keys and
manual
press Menu/Enter
mode
c At IO SETUP screen,
press LAN CONFIG
softkey
d At LAN
CONFIGURATION
screen, ensure IP
Configuration is
Manual
e If needed, press
Auto/Manual softkey
until Manual is
displayed and SAVE
f Press BACK softkey to
go back to IO SETUP
screen
Illustration
11713B/C Operating and Service Manual