11713B/C Operating and Service Manual
Supply Voltage for Bank 2. Indicates supply voltage setting
9
(background LED in red) for bank 2.
Switches for Bank 1. In the local mode, pushbutton switches 9
10
and 0 change the position of a coaxial switch connected to rear
panel banana jacks S9 A/B and S0 A/B respectively, for bank 1.
Switches for Bank 2. In the local mode, pushbutton switches 9
11
and 0 change the position of a coaxial switch connected to rear
panel banana jacks S9 A/B and S0 A/B respectively for, bank 2.
Attenuator Y for Bank 1. In the local mode, pushbuttons 5, 6, 7,
12
and 8 change the attenuation setting of an attenuator or change
the position of coaxial switch(es) connected to the ATTEN Y
connector on the rear panel, for bank 1.
Attenuator Y for Bank 2. In the local mode, pushbuttons 5, 6, 7,
13
and 8 change the attenuation setting of an attenuator or change
the position of coaxial switch(es) connected to the ATTEN Y
connector on the rear panel, for bank 2.
Attenuator X for Bank 1. In the local mode, pushbuttons 1, 2, 3,
14
and 4 change the attenuation setting of an attenuator or change
the position of coaxial switch(es) connected to the ATTEN X
connector on the rear panel, for bank 1.
15
Attenuator X for Bank 2. In the local mode, pushbuttons 1, 2, 3,
and 4 change the attenuation setting of an attenuator or change
the position of coaxial switch(es) connected to the ATTEN X
connector on the rear panel, for bank 2.
On/Standby. Press this key to switch between on and standby.
16
When power is supplied, the background LED is red. Pressing the
key once, switches the driver on and the background LED turns to
green.
Local. Press this key to control the driver from the front panel
17
when it is operating via the remote interfaces.
1
Introduction
21