Agilent Technologies 11713B Operating And Service Manual page 80

7
Remote Interface Configurations
80
Auto Mode
This mode is used when you are connecting 11713B/C via site LAN.
In auto mode, the IP Adress, Subnet Mask, and Default Gateway
values are obtained from the DHCP server or automatically assigned
and the values cannot be configured from the front panel.
To prepare 11713B/C for auto mode,
Step Action
1 Ensure your a Connect your computer and 11713B/C to LAN outlets using standard
computer LAN cable
and
b Make sure power is applied to your computer and verify that the
11713B/C
operating system is fully booted
are turned on
c Apply power to 11713B/C and background LED color turns red,
and
indicating standby mode.
connected to
d Allow 11713B/C to warm up for 15 seconds, then press the ON
LAN
button (LED turn from red to green)
2 Verify a Press Menu/Enter
11713B/C button on the front
LAN panel of 11713B/C
configuration
b Select IO using
is ready for
navigation keys and
auto mode
press Menu/Enter
c At IO SETUP screen,
press LAN CONFIG
softkey
d At LAN
CONFIGURATION
screen, ensure IP
Configuration is AUTO
e If needed, press
Auto/Manual softkey
until AUTO is
displayed and SAVE
f Press BACK softkey to
go back to IO SETUP
screen
Illustration
11713B/C Operating and Service Manual