HP 81200 User Manual page 128

Choosing the Kind of Measurement
Once the DUT has been modeled, its pins have been connected to
instrument channels, and channel parameters have been specified, it is
time to tell the system what kind of measurement is going to be performed.
This has to be done before setting up the stream of generated and expected
data, because different tests require different settings. Although the
procedure for setting up the data sequence is always the same, the
available segment options and result displays depend on the kind of
measurement.
N O T E
It is recommended to save settings repeatedly during test setup. You
should take care of the chosen measurement type and save the setting
under a file name that indicates the kind of measurement.
The kind of measurement is chosen from the Measurement Configuration
window. See
"How to Access the Measurement Configuration Window" on page 129
"How to Set the Measurement Configuration" on page 130
128
HP 81200 Data Generator/Analyzer Platform User Guide, Revision 2.1