Olivetti d-COPIA 3013MF Operation Manual page 138

Setting Send Restriction
You can restrict the other parties to which you send originals only to the ones registered in Permit FAX No. and Permit
ID No. as well as the ones registered in the Address Book. To change the sending restriction, follow the steps below.
Setting Reception Restriction
You can restrict incoming faxes so that you only receive originals from senders registered in Permit FAX No. and
Permit ID No. and senders registered in your Address Book. This mode also allows you to set a [Reject List] for
Reception Restriction so that reception from senders on the list of Rejected FAX numbers or from senders whose
Local FAX Number is not registered are rejected. To change the reception restriction, follow the steps below.
1
Press the System Menu/Counter key.
2
Press the  or  key to select [FAX].
3
Press the OK key.
4
Press the  or  key to select [TX/RX Restrict.].
5
Press the OK key.
6
Press the  or  key to select [TX Restriction].
7
Press the OK key.
8
Press the  or  key to select sending restriction. To not
use the sending restriction, select [Off]. To restrict the
other parties only to the ones registered in Permit FAX
No. and Permit ID No. as well as the ones registered in
the Address Book, select [Permit+Addr Book].
9
Press the OK key.
1
Press the System Menu/Counter key.
2
Press the  or  key to select [FAX].
3
Press the OK key.
4
Press the  or  key to select [TX/RX Restrict.].
5
Press the OK key.
6
Press the  or  key to select [RX Restriction].
7
Press the OK key.
8
Press the  or  key to select reception restriction. To
not use the reception restriction, select [Off]. To restrict
the other parties only to the ones registered in Permit
FAX No. and Permit ID No. as well as the ones
registered in the Address Book, select [Permit+Addr
Book]. To block incoming faxes from senders registered
in Reject FAX No., select [Reject List].
9
Press the OK key.
6-26
Setup and Registration