Advertisement
User instructions
STOPPING A PROGRAM
To cancel a program which is running:
•
Interrupt the program (see "
•
Press the START/PAUSE button
display will show "P0" and the dishwasher will immediately
switch to the end of the cycle and drain the tank (during this
process, the "START/PAUSE symbol will flash). When the
drain procedure ends, the end of cycle "End" message
appears on the display.
In case that the door is opened during the operation, to the next door
closing it is going to be necessary to start the program as shown in
paragraph "
S
TARTING THE PROGRAM
point in which it was interrupted.
In case that the tub temperature is higher than 50°C the program
will start about 60 seconds later.
INTERRUPTING A PROGRAM
and hold it down; the
". The program will resume from the
")
11
Advertisement
