Table of Contents
Advertisement
Problem
Unusual foam during washing.
Traces of rust on cutlery.
There are residues of detergent
in the dispenser at the end of the
programme.
Odours inside the appliance.
Limescale deposits on the table-
ware, on the tub and on the in-
side of the door.
Dull, discoloured or chipped ta-
bleware.
Refer to "Before first use", "Daily
use" or "Hints and tips" for other
possible causes.
TECHNICAL INFORMATION
Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
Power consumption
1) Refer to the rating plate for other values.
2) If the hot water comes from alternative source of energy, (e.g. solar panels, aeolian energy), use the hot
water supply to decrease energy consumption.
•
Use the detergent for dishwashers only.
•
There is a leak in the rinse aid dispenser. Contact an Author-
ised Service Centre.
•
There is too much salt in the water used for washing. Refer to
"The water softener".
•
Silver and stainless steel cutlery were placed together. Avoid
to put silver and stainless steel items close together.
•
The detergent tablet got stuck in the dispenser and therefore
was not completely washed away by water.
•
Water cannot wash away the detergent from the dispenser.
Make sure that the spray arm is not blocked or clogged.
•
Make sure that items in the baskets do not impede the lid of
the detergent dispenser from opening.
•
Refer to "Internal cleaning".
•
Refer to "The water softener".
•
Make sure that only dishwasher-safe items are washed in the
appliance.
•
Load and unload the basket carefully. Refer to basket loading
leaflet.
•
Place delicate items in the upper basket.
Width / height / depth (mm)
Voltage (V)
1)
Frequency (Hz)
Min. / max. bar (MPa)
Cold water or hot water
Place settings
Left-on mode (W)
Off-mode (W)
Possible cause and solution
596 / 818 - 898 / 555
220 - 240
50
0.5 (0.05) / 8 (0.8)
max 60 °C
2)
13
0.99
0.10
17
Advertisement
Table of Contents
