Table of Contents
Advertisement
Problem and alarm code
You cannot activate the appliance.
The programme does not start.
The appliance does not fill with water.
•
The end indicator flashes 1 time inter-
mittently.
•
Acoustic signal sounds 1 time intermit-
tently.
The appliance does not drain the water.
•
The end indicator flashes 2 times inter-
mittently.
•
Acoustic signal sounds 2 times inter-
mittently.
The anti-flood device is on.
•
The end indicator flashes 3 times inter-
mittently.
•
Acoustic signal sounds 3 times inter-
mittently.
The appliance stops and starts more
times during operation.
The program lasts too long.
Small leak from the appliance door.
The appliance door is difficult to close.
Rattling/knocking sounds from inside the
appliance.
Possible cause and solution
•
Make sure that the mains plug is connected to the
mains socket.
•
Make sure that there is no damaged fuse in the fuse
box.
•
Make sure that the appliance door is closed.
•
If the delay start is set, cancel the setting or wait for
the end of the countdown.
•
The appliance has started the procedure to re-
charge the resin inside the water softener. The dura-
tion of the procedure is approximately 5 minutes.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter in the inlet hose is not clog-
ged.
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or
bends.
•
Close the water tap and contact an Authorised
Service Centre.
•
It is normal. It provides optimal cleaning results and
energy savings.
•
If the delayed start option is set, cancel the delay
setting or wait for the end of the countdown.
•
The appliance is not level. Loosen or tighten the ad-
justable feet (if applicable).
•
The appliance door is not centred on the tub. Adjust
the rear foot (if applicable).
•
The appliance is not level. Loosen or tighten the ad-
justable feet (if applicable).
•
Parts of the tableware are protruding from the bas-
kets.
•
The tableware is not properly arranged in the bas-
kets. Refer to basket loading leaflet.
•
Make sure that the spray arms can rotate freely.
15
Advertisement
Table of Contents
