Supporting The Motorcycle - Yamaha XT250 2008 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
1
1
2
3
1. Turn signal light bulb
4
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
5
4. Install the lens by installing the
screw. NOTICE: Do not over-
6
tighten the screw, otherwise the
lens may break.
7
8
9

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other maintenance
requiring the motorcycle to stand up-
right. Check that the motorcycle is in a
stable and level position before starting
any maintenance. A strong wooden
box can be placed under the engine for
added stability.
To service the front wheel
1. Stabilize the rear of the motorcycle
by using a motorcycle stand or, if
an additional motorcycle stand is
not available, by placing a jack un-
[ECA11191]
der the frame in front of the rear
wheel.
2. Raise the front wheel off the
ground by using a motorcycle
stand.
To service the rear wheel
Raise the rear wheel off the ground by
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
a jack either under each side of the
EAU24350 frame in front of the rear wheel or under
each side of the swingarm.
7-36