Adjusting The Rear Brake Light Switch; Checking The Front And Rear Brake; Pads - Yamaha XT250 2008 Owner's Manual

direction (b).
3. Tighten the locknut.
WARNING
G After adjusting the brake lever
free play, check the free play
and make sure that the brake is
working properly.
G
A soft or spongy feeling in the
brake lever can indicate the
presence of air in the hydraulic
system. If there is air in the hy-
draulic system, have a Yamaha
dealer bleed the system before
operating the motorcycle. Air in
the hydraulic system will dimin-
ish the braking performance,
which may result in loss of con-
trol and an accident.
PERIODIC MAINTENANCE AND ADJUSTMENT
Adjusting the rear brake light
switch
EWA10630
(a)
1. Rear brake light switch
2. Adjusting nut
The rear brake light switch, which is ac-
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
Turn the rear brake light switch adjust-
ing nut while holding the rear brake light
switch in place. To make the brake light
come on earlier, turn the adjusting nut
in direction (a). To make the brake light
come on later, turn the adjusting nut in
direction (b).
EAU22271
Checking the front and rear
brake pads
The front and rear brake pads must be
checked for wear at the intervals spec-
ified in the periodic maintenance and
1
lubrication chart.
(b) Front brake pads
2
1. Wear indicator groove
Each front brake pad is provided with a
wear indicator groove, which allows
you to check the brake pad wear with-
out having to disassemble the brake.
To check the brake pad wear, check
the wear indicator groove. If a brake
pad has worn to the point that the wear
7-23
EAU22390
EAU22420
1
2
3
4
5
6
7
8
9