Replacing The Fuse; Replacing The Headlight Bulb - Yamaha XT250 2008 Owner's Manual

Replacing the fuse

1
1. Fuse
2. Spare fuse
The fuse holder is located behind panel
C. (See page 7-9.)
If the fuse is blown, replace it as fol-
lows.
1. Turn the key to "OFF" and turn off
all electrical circuits.
2. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
[EWA15131]
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU23503
Specified fuse:
20.0 A
2
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows
again, have a Yamaha dealer
check the electrical system.

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
NOTICE
Do not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency of
the glass, the luminosity of the bulb,
and the bulb life will be adversely af-
fected. Thoroughly clean off any dirt
and fingerprints on the headlight
bulb using a cloth moistened with al-
cohol or thinner.
1. Do not touch the glass part of the bulb.
7-33
1. Remove cowling
EAU23814
ECA10660
2
3
4
5
6
7
8
9
A. (See