About The Shortcut Key; About The Indicator Display; Opening Screen Customization - Alpine X409 Owner's Manual

About the Shortcut Key

There are two shortcut keys on Audio source screen (Radio, USB Audio,
etc.). You can quickly switch to Sound Setup screen or Phone Menu
screen by touching the shortcut key.
Sound setup shortcut button
Touch to display Bal./Fad. Screen of Sound setup. Refer to
"Setting the Balance/Fader/Rear Speaker/Subwoofer" (page 32).
Phone shortcut button
Touch to display Phone Menu screen. Refer to "Hands-free
Phone Control" (page 77).

About the Indicator Display

The Indicator Bar at the bottom of the screen displays various types of
information, like the current time.
Lights up when connected to a Bluetooth compatible
device. (Does not display when connection is set to OFF.)
: Bluetooth connection to audio device
: Bluetooth connection to Hands Free Phone
Blinks while reconnecting.
Indicates the battery level of the connected Bluetooth
device*.
Battery
Level 3
Level
Icon
This may not be displayed depending on the connected
Bluetooth device. Whenever one battery level decreases, the
alarm sounds.
22
-EN
Level 2 Level 1 No Battery
Indicates the signal strength level of the connected
Bluetooth compatible device*.
Displayed when Bluetooth setting is ON.
0 1
Plasmacluster indicator
Indicates the setting value (Low/Mid/High) selected in
"Plasmacluster air volume adjustment. "
The clock display
You can switch between the 12 hour display and 24 hour display
options.
For details of the clock display settings, refer to "Navigation
System OM" in the website at http://www.alpine-usa.com.
Bluetooth devices Name*
* When you connect two Hands-Free Phones, the information of the
Bluetooth device set to Primary is displayed.

Opening screen Customization

You can set a BMP image that is stored on a USB flash drive as the
opening screen.
This setting requires the following image format, folder name and file
name.
Usable file format:
- BMP image
- Image size: 800 × 480 pixels (RGB 24 bit or less/number of color bit:
24, 8, 1 bit)
- Compression format: non-compressed
1
- Folder name* : OPENINGFILE
2
- File name* : openingfile.bmp
1
Connect the USB flash drive to the USB extension cable.
A message confirming the opening screen change is displayed.
2
Touch [OK].
An update indicator " (Loading)" is displayed, and update for
the opening screen starts.
3
After the update is complete, the following message is
3
displayed.*
"The logo has been updated successfully! Please remove Flash
Memory and press OK. "
4
After removing the USB flash drive, touch [OK].
The opening screen setting is complete.
*1 Be sure to save the folder to the first layer of the USB flash drive.
*2 Only one BMP image can be set as the opening screen.
*3 If "Customization failed, " is displayed, touch [OK] and then check that
the folder name, file name and file format are correct.
• Do not perform the following actions during the update.
- Do not turn off the ACC to the car.
- Do not unplug the USB flash drive.
- Do not turn off or operate the unit.
• To return the opening screen to its original image, you must Clear All
Settings. Be careful of this operation, as your other settings are also
initialized. For details, see "Initializing the System" (page 40).
2 3 No Service