Troubleshooting - LG HR902TA Owner's Manual

Troubleshooting

Check the following guide for the possible cause of a problem before contacting service.
Symptom
No power. The power cord is disconnected.
No picture.
The TV is not set to receive recorder
signal output.
The video cable is not connected
securely.
The connected TV power is turned off.
No sound. The equipment connected with the
audio cable is not set to receive
recorder signal output.
The audio cables are not connected
securely.
The power of the equipment connected
with the audio cable is turned off.
The audio connecting cord is damaged.
The playback picture is The disc is dirty.
poor.
The recorder does not No disc is inserted.
start playback.
An unplayable disc is inserted.
The disc is placed upside down.
The disc is not placed within the
guide.
The disc is dirty.
The Rating level is set.
The picture from the The video signal from the external
external input is component is copy-protected.
distorted
Some channels are Those channels are not stored in the
skipped over when recorder.
using v / V.
The picture or sound of Aerial or cables are loose.
broadcasting channel is
weak or missing.
Camcorder image is not Camcorder is off.
shown.
Camcorder image via The recorder's source is incorrect.
A/V input or DV IN to
recorder is not shown
on TV screen.
Radio stations cannot
The antenna is positioned or
be tuned in. connected poorly.
CHECK CABLE appears The system cable is connected
in the Display window. incorrectly.
Cause
Plug the power cord into the wall
outlet securely.
Select the appropriate video input mode
on the TV so the picture from the
recorder appears on the TV screen.
Connect the video cable securely.
Turn on the TV.
Select the correct input mode on the
audio receiver so you can listen to the
sound from the recorder.
Connect the audio cable securely.
Turn on the equipment connected
with the audio cable.
Replace it with new one.
Clean the disc.
Insert a disc. (Check that the disc
indicator in the display window is lit.)
Insert a playable disc. (Check the disc
type, color system, and regional code.)
Place the disc with the playback side
down.
Place the disc on the disc tray
correctly inside the guide.
Clean the disc.
Cancel the Rating function or change
the rating level.
You cannot connect via this recorder.
Connect the component directly to
your TV.
Restore channels. See "Program Edit"
on page 20.
Tighten connections or replace cable.
Turn camcorder on and operate
properly.
Use AV to select input channel (AV1,
AV2, DV, etc.)
Connect the antenna securely
Adjust the antennas and connect an
external antenna if necessary.
Check the status of connection and
connect the system cable securely
Solution
.
.
59