Connections To Your Tv - LG HR902TA Owner's Manual

Connections to Your TV

Make one of the following connections, depending
on the capabilities of your existing equipment.
When using the COMPONENT/PROGRESSIVE
SCAN VIDEO OUT jacks, set the Video output
format option in the setup menu to YPbPr. When
using the SCART jack, set the Video output format
option in the setup menu to RGB.
Tips
Depending on your TV and other equipment you
wish to connect, there are various ways you could
connect the recorder. Use only one of the
connections described below.
Please refer to the manuals of your TV, VCR,
Stereo System or other devices as necessary to
make the best connections.
Caution
Make sure the recorder is connected directly to the
TV. Tune the TV to the correct video input channel.
Do not connect the recorder's AUDIO OUT jack to
the phono in jack (record deck) of your audio
system.
Do not connect your recorder via your VCR. The
DVD image could be distorted by the copy
protection system.
Rear of TV
VIDEO
AUDIO INPUT COMPONENT VIDEO INPUT
INPUT
Pr
L R Y Pb
V A C (Not supplied)
Rear of the HDD/DVD
Recorder Receiver
O (Not supplied)
OPTICAL
OUT
DVD Player (or Digital
Device, etc)
Video connection
Connect the VIDEO OUT jack on the recorder to the
video in jack on the TV using the video cable (V).
Audio (Left/Right) Connection
Connect the left and right AUDIO OUT jacks of the
recorder to the audio left and right IN jacks on the TV
using the audio cables (A). Do not connect the
recorder's AUDIO OUT jack to the phono in jack
(record deck) of your audio system.
Component Video connection
Connect the COMPONENT / PROGRESSIVE SCAN
VIDEO OUT jacks on the recorder to the
corresponding input jacks on the TV using an Y Pb Pr
cable (C).
If your television is a high-definition or "digital ready"
television, you may take advantage of the recorder's
progressive scan output for the highest video
resolution possible. If your TV does not accept the
Progressive Scan format, the picture will appear
scrambled if you try Progressive Scan on the recorder.
Set the resolution to 576p using RDS/RESOL. button
for progressive signal.
Note:
Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack) connection.
SCART connection
SCART INPUT Connect the EURO AV1 AUDIO/VIDEO scart jack on
the recorder to the corresponding in jacks on the TV
using the scart cable (T).
Optical Digital Connection
T
Connect an optical output of DVD Player (or Digital
Device etc) to the OPTICAL IN connector on the
recorder using the optical cable (O).
Note:
When the Optical jack is connected, audio will output
from speakers of the main unit amplifier only but the
audio output is not available via the HDMI and AV
jacks.
11