Advertisement
1.2 Installation procedure
1.2.1 Mounting to the
Host Machine
1) Turn off the main power switch, and disconnect the
power plug.
2) Remove the rear cover [1].
- 4 screws [2]
[2]
[1]
F-1-2
3) Remove the rear left cover [1].
- 3 screws [2]
[1]
F-1-3
All manuals and user guides at all-guides.com
[2]
3
4) If a Super G3 Fax Board-T1 is found, disconnect
the connector [1] of the IP-modem cable.
If an optional Super G3 Fax Board-T1 is found, the
SDRAM and the super capacitor remain powered to
back up the image memory (even after the main power
switch has been turned off and the power plug has
been disconnected).
Be sure to disconnect the IP modem cable before
removing the RAM.
F-1-4
5) Remove the RAM cover [1].
- 4 screws [2]
[2]
F-1-5
[1]
Advertisement
