Beep; Default Values (Reset); Rinsing; Making Coffee - DeLonghi ECAM35X.50 Instructions For Use Manual

OK icon (B15) to confirm (or
5. Press the
to exit without making any change). The lights go off.
The energy saving setting is now programmed.
Please note:
• In energy saving mode, a few seconds may elapse before
the first coffee is delivered as the appliance must heat up
again.

10. BEEP

This function enables or disables the beep. Proceed as follows:
1. With the machine off (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon
touch screen (B) light up.
3. Press the icon to enable/disable the function:
•
•
OK icon (B15) to confirm (or
4. Press the
to exit without making any change). The lights go off.
The beep is now programmed.

11. DEFAULT VALUES (RESET)

This function resets all settings (temperature, auto-off, water hard-
ness, energy saving and all quantity settings are reset to the default
values).
1. With the machine off (in standby mode) but still plugged
into the electrical power supply;
2. Press and hold the icon
touch screen (B) light up.
3. Press the icon (B12): the beans (B7) on the touch
screen will blink;
OK icon (B15) to reset the default values (or
4. Press the
ESC (B14) to exit without making any change). The
lights go off.
The settings and quantities of the beverages have been reset to
the default values.

12. RINSING

Use this function to deliver hot water from the coffee spouts
(A9) to clean and heat the appliance's internal circuit.
Place a recipient under the coffee and hot water spouts.
Important! Danger of scalding.
Do not leave the appliance unattended while hot water is being
delivered.
1) To activate the function, press
2) After a few seconds, hot water is delivered from the cof-
fee spouts, cleaning and heating the appliance's internal
circuit.
ESC (B14)
(B9) until the indicators on the
function enabled
function disabled
ESC (B14)
(B9) until the indicators on the
OK(B15);
3) To interrupt the function manually, press
Please note:
• If the appliance is not used for more than 3-4 days, when
switched on again, we strongly recommend performing
2/3 rinses before use;
• AFTER cleaning, it is normal for the coffee grounds con-
tainer (A11) to contain water.

13. MAKING COFFEE

13.1 Adjusting the coffee mill

The coffee mill is set by default to prepare coffee correctly and
should not require regulating initially.
However, if after the first few attempts it becomes apparent that
the coffee is either too weak and not creamy enough, or emerg-
es too slowly (drop by drop), this can be corrected by adjusting
the grinding adjustment dial (A5) (fig. 7).
Please note:
The grinding adjustment dial must be used only when the coffee
mill is in operation.
If the coffee is delivered too slowly or not
at all, turn one click clockwise towards 7.
For fuller bodied creamier coffee, turn
one click anticlockwise towards 1 (do not
turn more than one click at a time other-
wise the coffee could be delivered a drop
at a time).
The effect of the adjustment will be noticed only after making
a further 2 cups of coffee, at least. If this adjustment does not
produce the desired result, turn the dial another click.

13.2 Tips for a hotter coffee

To make a hotter coffee, proceed as follows:
• perform a rinse cycle by pressing
• warm the cups with hot water using the hot water function
(see section "15. Delivering hot water");
• increase the coffee temperature (see section "18. Setting
water hardness").
8
OK again.
7
OK (B15);