Auto-Off; Energy Saving; Beep; Default Values (Reset) - DeLonghi Dinamica ECAM35X.15 Instructions For Use Manual

2. Press and hold the
touch screen (B) come on;
3. Press the icon (B10);
4. Press the icon again to select the required
temperature:
5. Press the OK icon (B15) to confirm (or
(B14) to exit without making the change).
The lights go off.
The appliance returns to "standby" and the temperature is now
programmed.

10. AUTO-OFF

The time can be changed so that the appliance switches off after
being idle for 15 or 30 minutes, or after 1, 2 or 3 hours.
To change the Auto-off setting, proceed as follows:
1. With the appliance off (standby), but the main switch
pressed (fig. 1);
2. Press and hold the
touch screen (B) come on;
3. Press the icon (B11);
4. Select the required time interval by pressing the
again:
icon (B9) until the lights on the
low
medium
high
maximum
icon (B9) until the icons on the
15 min.
30 min.
1 hour
2 hours
3 hours
5. Press the
(B14) to exit without making the change). The lights go off.
The auto-off time is now programmed.

11. 11. ENERGY SAVING

Use this function to enable or disable energy saving. This mode
is active by default, reducing energy consumption while the ma-
chine is on in compliance with current European regulations. To
change the setting, proceed as follows:
1. With the appliance off (standby), but the main switch
pressed (fig. 1);
2. Press and hold the
touch screen (B) come on.
3. Press the
4. Press the
•
•
ESC
5. Press the
(B14) to exit without making the change).
6. Press
The energy saving setting is now programmed.
Please note!
• When in energy saving mode, a few seconds may elapse
before the first coffee is delivered as the appliance must
heat up again.

12. 12. BEEP

This function enables or disables the beep. Proceed as follows:
1. With the appliance off (standby), but the main switch
pressed (fig. 1);
2. Press and hold the
touch screen (B) come on.
icon
3. Press the
•
•
4. Press the
(B14) to exit without making the change). The lights go off.
The beep is now programmed.

13. DEFAULT VALUES (RESET)

This function resets all settings (temperature, auto-off, water hard-
ness, energy saving and all quantity settings are reset to the default
values).
1. With the appliance off (standby), but the main switch
pressed (fig. 1);
2. Press and hold the
touch screen (B) come on.
11
OK icon (B15) to confirm (or
icon (B9) until the icons on the
icon (B13);
icon again to enable/disable the function:
function enabled
function disabled
OK icon (B15) to confirm (or
ESC to exit the menu. The lights go off.
icon (B9) until the lights on the
icon to enable/disable the function:
function enabled
function disabled
OK icon (B15) to confirm (or
icon (B9) until the lights on the
ESC
ESC
ESC