Preparing Coffee With Pre-Ground Coffee; Customizing Aroma And Quantity; Making Cappuccinos And Milk-Based Coffees; Filling And Attaching The Milk Container - DeLonghi ECAM35X.50 Instructions For Use Manual

13.5 Preparing coffee with pre-ground coffee

Important!
• Never add pre-ground coffee when the machine is off or it
could spread through the inside of the machine and dirty
it. This could damage the machine.
• Never use more than 1 level meas-
ure (C2) as it could dirty the inside
of the coffee machine or block the
funnel (A4).
Please note:
When using pre-ground coffee, only one cup can be made at a
time.
1. Press the button (B8) repeatedly, until the
cator light (B6) appears.
2. Make sure the funnel is not blocked, then add one level
measure of pre-ground coffee (fig. 11).
3. Place a cup under the coffee spouts (A9) (fig. 9);
4. Then select your required coffee:
Recipe
Espresso (B10)
Coffee (B11)
5. Preparation begins and the indicator light corresponding
to the selected icon blinks on the touch screen (B).
Please note:
If "Energy Saving" mode is active, you may have to wait a few
seconds before the first coffee is delivered.

13.6 Customizing aroma and quantity

The appliance is set by default to make coffee with a standard
aroma and quantity (see table in section "13.3 Making coffee
using coffee beans").
To customize the coffee, proceed as follows:
indi-
11
Quantity
≃ 40 ml
≃ 180 ml
1. Place a sufficiently large cup or glass under the coffee
spouts (A19);
2. Press (B8) to select the desired aroma (see section
"13.4 Temporarily varying the coffee aroma");
3. Press and hold the icon corresponding to the coffee to be
customized: the icon blinks and all the alarm indicator
lights also blink;
4. Release the icon. The icon blinks and the appliance starts
delivering coffee;
5. As soon as the coffee in the cup reaches the required level,
press the coffee icon again.
The aroma and quantity of coffee in the cup has now been
programmed.
14. MAKING CAPPUCCINOS AND MILK-BASED
COFFEES
Please note:
• To avoid milk with poor froth or large bubbles, always clean
the milk container lid (D2) and hot water connection noz-
zle (A8) as described in sections "14.5 Cleaning the milk
container after use", "16.10 Cleaning the milk container"
and "16.11 Cleaning the hot water nozzle".

14.1 Filling and attaching the milk container

1. Remove the lid (D2) (fig. 12);
2. Fill the milk container (D3) with a sufficient quantity of
milk, not exceeding the MAX level marked on the contain-
er (fig. 13). Each mark on the side of the container corre-
sponds to 100ml of milk;
Please note:
• For a denser and more evenly distributed froth, always use
skimmed or partially skimmed milk at refrigerator temper-
ature (about 5 °C).
• If "Energy Saving" mode is enabled, you may have to wait a
few seconds before the first cappuccino is delivered.
3. Make sure the milk intake tube (D4) is correctly inserted in
the bottom of the milk container lid (fig. 14)
10
12 13